Dracul
About
- Username
- Dracul
- Joined
- Visits
- 33
- Last Active
- Roles
- Member
Comments
-
Alright, so I messed with the backlash, did this test: https://www.thingiverse.com/thing:2256550 X became perfect, but no matter what I set Y backlash the backlash was never in ranges of the test. So I tried a new stepper driver and someh…
-
For sanity reasons, when you say backlash, you mean acceleration and jerk settings right? Can't find any specific "backlash" settings in Repetier Host. I just spent the last two days going over everything. Mechanically, everything should check out…
-
The cal cube I'm using is this one. All letters are indents: https://www.thingiverse.com/thing:1278865
-
Its not. I had to take apart the X-Axis completely to fix the upper liner rod. Upon reassembly, I made sure everything was good to go and put together properly. No loose parts and it cannot move.
-
Alright, I did check and admittedly... did find that the top linear rod on the X-Axis was completely loose (really unsure how it came loose). However, that didn't seem to change too much. Comparisons: Left is the last one and Right is the fixed. T…