wirelessguyny
About
- Username
- wirelessguyny
- Joined
- Visits
- 2
- Last Active
- Roles
- Member
Comments
-
I tried this. Here is the answer and solution that may suprise you. I don't know if this is a bug or intentional but on windows you MUST leave the com port speed in Device Manager at 9600!!! Both Repetier and the Marlin firmware can have higher …
-
Some added info... Apparnetly Pronterface is able to connect at 250000 Baud and reads off some data from the printer. However... if I use that baud setting in Repetier after the successful connect the board resets itself again and again. I've tried …