ojasV

Yes I've kept it disabled since I didn't fully understand it while building the firmware. One more thing, my extruder steps/mm are 95. It uses a 1.8 degree 1.5A motor. How do I find out the maximum retraction speed it can achieve?

in Do slicer parameters like retraction settings override firmware settings? Comment by ojasV September 2017

So I read a little and I understand that the firmware values are used if AutoRetractConvert is enabled. Else, slicer values are used. Is that correct?

in Do slicer parameters like retraction settings override firmware settings? Comment by ojasV September 2017

ojasV said: So for retraction, the printer will always use: RETRACTION_LENGTH 3 RETRACTION_SPEED 40 RETRACTION_Z_LIFT 0 right? And it won't make any difference what values I give to "Retraction Distance", "Extra Restart Distance" & "Retr…

in Do slicer parameters like retraction settings override firmware settings? Comment by ojasV September 2017

When exactly are G10 and G11 used, if for all printing moves the slicer dictates the retraction values? - G10 S retracts filament according to stored setting- G11 S = Undo retraction according to stored setting I understand that G1 X Y Z E will c…

in Do slicer parameters like retraction settings override firmware settings? Comment by ojasV September 2017

So for retraction, the printer will always use: RETRACTION_LENGTH 3 RETRACTION_SPEED 40 RETRACTION_Z_LIFT 0 right? And it won't make any difference what values I give to "Retraction Distance", "Extra Restart Distance" & "Retraction Vertical Lif…

in Do slicer parameters like retraction settings override firmware settings? Comment by ojasV September 2017

Repetier said: max. prinable radius is a contrain and remember that to issued coordinates you have to add z probe offsets to see what it will really test and which position needs to be valid. At a position like 100,100 your radius is 142 plus…

in Confusing results with G33 and Bed Height Map tool for a Delta printer Comment by ojasV September 2017

Alright. But I still don't understand why Repetier Host stopped responding when I changed printer radius to 142 and ran bed height map tool. Should I try a higher value, say 150 and run it again to see what happens?

in Confusing results with G33 and Bed Height Map tool for a Delta printer Comment by ojasV September 2017

Repetier said: G33 omits edges if you have compiled it with the flag set. Can you please explain? I have mentioned my distortion parameters in an earlier comment. Moreover G33 isn't omitting anything, it is measuring all points of a 5x5 m…

in Confusing results with G33 and Bed Height Map tool for a Delta printer Comment by ojasV September 2017

Actually G33 is using a proper 5x5 point matrix whereas the Bed Height Map tool isn't using the four corner points. So (-100,-100), (100,-100), (100,100) and (-100,100) are not being measured by the Bed Height Map tool. Shouldn't it be the reverse? …

in Confusing results with G33 and Bed Height Map tool for a Delta printer Comment by ojasV September 2017

My Z_PROBE_BED_DISTANCE was set to 10. I started the "Bed Height Map" tool at Z=10 and that cleared the confusion. However, I still have a few queries. Here are my distortion correction values: #define DISTORTION_CORRECTION 1 #define DISTORTION_COR…

in Confusing results with G33 and Bed Height Map tool for a Delta printer Comment by ojasV September 2017

Alright, so turns out the diagonal rod length and printer radius both were off. My bad. I fixed them both, re-uploaded the firmware, did the entire calibration routine and hit no snags. One question though. While calculating tower endstop offsets us…