› ›

Plumpeken

About

Username
Plumpeken
Joined
Visits
16
Last Active
Roles
Member

Comments

  • Repetier said: In deltas the diagonal rot length is responsible for the xy size. Unfortunately if you change that you get a ump/dome in the center, so you also need to adjust horizontal radius to correct the resulting geometry error. Where…
    in Delta Printer print sizes wrong Comment by Plumpeken September 2017
  • MartinH said: What type of extruder,  bowden or direct drive ? What retraction length do you have set in the slicer atm ? Repetier said: Yäou can add extra extrusion length after retract if the problem is that big. In general on sta…
    in Under Extrusion after a retract Comment by Plumpeken August 2017