ksdfpr
About
- Username
- ksdfpr
- Joined
- Visits
- 4
- Last Active
- Roles
- Member
Comments
-
I still have problem with g0 commands in my delta using dev version. Some g0 commands (not all) enables laser. Beside this, m3 makes the laser on (shown in log) but not the same as m5 (write nothing in log). (my config is available if you want)
-
Does g0 command laser on fixed?
-
Mmmmm, I tried the jphotonic plugin and I got also same results. So it's Inkscape problem...
-
No, not import . I draw a single line 100mm. Everywhere has mm units. In paper is printed normal. And I have reinstalled Inkscape 2-3 times (except something "wrong" is staying in win directories?)
-
I solved this by increasing the difference between travel speed and laser speed a few units or adding a g0 x0 y0 before first move!!! What about this? " 100mm line long (x=0, y=0) in inkscape are been transformed to G1 X28.2222 Y0???"
-
RAyWB said: ksdfpr said: The first g0 command (used to move to the start point for lasering) is executed with laser ON. what type of printer do you have? Geeetech G2S pro (delta)
-
and finaly why 100mm line long (x=0, y=0) in inkscape are been transformed to G1 X28.2222 Y0??? getting crazy 8-}
-
So, i decided to forget ttl input, lets go to laser lines. The first g0 command (used to move to the start point for lasering) is executed with laser ON. Sometimes is on also to the last g0 command... I have connect the laser to 2nd hotend terminal…
-
Thank you for the answer. I have multiple problems to setup it correctly that why I don't want to assume... TTL input is not connected at all, right? Vin is connected to (second) hot end, setuped already in firmware. The plugin produce gcode, an…
-
Sorry, I missed you I want more details, please read my first post!
-
Thanks for the reply. I have this http://www.ebay.com/itm/332081247422?_trksid=p2060353.m2749.l2649&ssPageName=STRK:MEBIDX:IT