wfpaez
About
- Username
- wfpaez
- Joined
- Visits
- 8
- Last Active
- Roles
- Member
Comments
-
I disabled the G10/G11 section, added scripts to the Tool Change sections and am now just fine tuning the retraction values. So far, all is working just fine. Thanks!
-
EEPROM values: I have that disabled. I think my RADDS' EEPROM is non-functional. In the menus, I saw no area where I could adjust retraction (under Extruder, Settings or Setup). I will look again. I'll take out the M209 commands from my slicer s…
-
200mm was extreme. It turns out I only need 45mm. But, the retraction isn't working, even though I turn it on with M209 S1 in the starting script (and off again in the ending script). That is, the retraction isn't the 50mm I was expecting, but so…
-
Oh, good. That's how it is now. The extruder only has space for one heater. I saw that retraction was happening when the tools were changed without the Start/End scripts and I see where that is configured. But, I don't think the distance I en…
-
I have SHARED_EXTRUDER_HEATER enabled. I will re-configure without this option.
-
I did (in last night's installation) configure the temperature sensor pins to match T0. The temperatures now all appear and they match. The menu also allowed me to change filament for each extruder. I think I left MIXING_EXTRUDER disabled, but I'…
-
Update: I changed my configuration to not recognize M106 commands for Fan2 and just left it coupled to T0. The same configuration.h worked in 1.0.1 and 1.0.1dev.
-
Updating the firmware of the 16U2 allowed both EEPROM 0 and Simplify3D to work. Since the RADDS board isn't connected to any sensors, it is chirping away about missing temperatures, so that's good. I'm going to update the spare board and perform …
-
Correct. When I have the RADDS module plugged in, with the LCD, it hangs with EEPROM = 1 (or 2). A few months ago, when this first happened, I modified the firmware so it would report where the failure was (result: EEPROM was not responding). May…
-
Thank you - I'll give this a try!
-
And a little more... New Due - first Sketch I tried to load to it was a known, working Repetier firmware. The load was successful but Repetier did not start (two bars). Loaded Blink - that worked. Tried Repetier with EEPROM 0 That worked. Trie…
-
A little late, but... I just encountered this as well. I purchased new Dues (I think I'm up to three, including an 'original'). None of the replacement Dues would work. The firmware installed properly (newly configured and known-working), but sa…
-
Hello, I had the same issue with my RADDS and DRV8825s. The mechanicals are the PowerSpec Ultra3D - everything worked fine with the FlashForge driving it. But, with RADDS+DRV8825, I had the vertical ripples. On my X,Y,X I had 1/32 micro stepping b…