t4h3r
About
- Username
- t4h3r
- Joined
- Visits
- 14
- Last Active
- Roles
- Member
Comments
-
Yeeeeeeeeeeees i change the Y drive and i think it works ok now thank dude
-
thanks guys i got a new extruder and it works great
-
Chinese one i know the pla prints at 180-200 but it does not melt with me at 200 - even 280
-
i had clean it then try manual feeding it works alright with 400 ْ is that's alright ?
-
no error appears during heating or printing and temperature curve looks alright but the filament is stuck inside the hot end i try to clean it a lot of time but i always got the same problem
-
#define PDM_FOR_EXTRUDER 0#define PDM_FOR_COOLER 0#define DECOUPLING_TEST_MAX_HOLD_VARIANCE 20#define DECOUPLING_TEST_MIN_TEMP_RISE 1#define KILL_IF_SENSOR_DEFECT 0#define RETRACT_ON_PAUSE 2#define PAUSE_START_COMMANDS ""#define PAUSE_END_COMMANDS "…
-
Z Problem Also Solved Many Thanks Guys
-
thanks guys you are the best i've change the thermistor and now it works ok .... now i still has the z axis problem when i try to print some thing z axis launches up about 120mm after homing i try to minimize ZAXIS_STEPS_PER_MM 2650 but no thin…
-
i am completely beginner so please try to make simple it as u can regards
-
01:30:36.700 : T:500.00 /0 B:-50.88 /0 RAW1:4092 B@:0 @:0 RAW0:0WAIT WAIT WAIT
-
Its connected