killrmodz
About
- Username
- killrmodz
- Joined
- Visits
- 10
- Last Active
- Roles
- Member
Comments
-
Ok, thank you!
-
Because if that is really the case, my g32 command doesn't do a z max after probing... so back to square one.
-
Ok. So if that's the case if I do a g28 first, then g32 it shouldn't do a z max afterwards? Sorry just got confused... LOL
-
Sorry that didn't make sense. I mean that is why we home first so when it probes it can established a true z max. Yes?
-
Ok, so it get's z height based on the z max homing, or g28? If i'm understanding correctly, because that makes sense as to why it will not go to z max after probing.
-
Repetier, so I have it working now. But after probing the 3rd point, it will not go back to home to figure z max. I'm using G32 S2 after running a G28. Any advice?
-
This is what I have... I don't see a NaN. Where esle would I find that entry? // #################### Z-Probing ##################### #define Z_PROBE_Z_OFFSET 0 #define Z_PROBE_Z_OFFSET_MODE 0 #define UI_BED_COATING 1 #define FEATURE_Z_PROBE 1 #d…
-
Yes, that's what it seems like.
-
I'm sorry it's the Repetier firmware 92.9. But I did figure it out. PWM control doesn't like have SSR's to manage. Read elsewhere that bang bang control is better suited for how I have my custom heatbed setup. Thanks! Love the firmware though!!
-
Fireware is what ever is the latest before the beta offered. Yes, the let for the bed turns off. It goes up an few degrees and that's it. It obviously doesn't go any higher becuase it is turned off. No, as far as I know, being new to this, it d…
-
Same for the hotend... I noticed the Dry Run button. Do I have to do a dry run to test/verify the heating parts?
-
The bottome log doesn't shot anything but the command that turns on the bed. M140 s84*98... and that's it... Is there another log that i'm missing here?
-
Ok, I'll do the logs and see what it says then report back. Thanks!