touchthebitum
About
- Username
- touchthebitum
- Joined
- Visits
- 11
- Last Active
- Roles
- Member
Comments
-
Ok thanks for the reply
-
No and my friend with the same printer has the same problem..
-
It doesn't work, autologin activated and always console ... Where can I find older versions other than 0.86 ?
-
Hello Thanks Yes I set the right region. I have a 3.5'' screen and I hav to download drivers to make it work. I'll check the autologin but I don't remember if I saw it ...
-
Yesterday I tried to install anyway the new version with the image provided on the Repetier server website. I can't make work wlan0 with a IP address. I can see Repetier server when attached to my router through ethernet but wifi not. I validated Wl…
-
But how can we able autoupdater function because I'm not sure ? Thanks
-
you're right. I think I already did the autoupdate because I have an end printing message that I didn't have before
-
Ok, I'll try that. Problem is that I also have problem with the non working touchscreen and cannot see if there is a conection.
-
I have a PI 3 Model B and has an integrated wifi. I don't understand how to access to the console since Repetier Server firmware boots to the license registration page ... Usually I use Putty to access.
-
I don't remember if it was an Raspberry image or an atmel image at that time. I remember I had to setup manually something but with this new Raspberry image, I don't know how to do since I only have the Repetier start screen with serial key to enter…
-
Ok ,now I understand. I have a LCD screen for my Raspberry. I'll buy a license Thanks for this great software
-
Thanks but I don't understand because I have a Qrcode on the screen and I can't do anything. I have to enter a valid license number to go on ...