Rick2
About
- Username
- Rick2
- Joined
- Visits
- 73
- Last Active
- Roles
- Member
Comments
-
That was it, thanks
-
Removed the windows server and everything is working. I bought the server pro version yesterday but can't find instructions on how to install on raspberry pi. Is it the same as installation of the free version? Do it via the pi terminal? Will that …
-
One other thing. When I choose com3 in server and I try to activate the printer it goes from orange to white.
-
I have installed the usb serial driver and when I connect the printer to the laptop with a usb cable I use com6. The printer works fine like this. I'm trying to connect wirelessly to thr rambo board via raspberry pi. The only choice I have in the se…
-
As a follow up I Uninstalled and reinstalled server on my computer and still only get the same 3 choices in the drop down menu. Any suggestions on how I can fix this?
-
That must be my problem. I thought the /dev/tty.USB0 was originally in the server drop down menu but now it doesn't show up. My only choices are com3, virtualdelta and virtualcartesian. Did I corrupt something?
-
I've checked all baud rate entries and they are all 250000 as they have been all along. I used the /dev/tty.USB which is what the server setup program prompts me to use for linux. I have noticed that I used a "." after the tty which I've seen isn'…
-
Didn't want to leave this open ended. The temperature problem was due to a burned out thermister. I thought if a thermister went bad it would read 0, not fluctuate like it was. Thanks for the help.
-
Now I can't even get around once for a skirt. All this started after I ran the heat calibration wizard. I reinstalled both host and server and it's worse than before.
-
How do I get out of dry run mode? Printer won't run more than 5 minutes without stopping now.
-
Not sure what you mean by allowing a bigger deviation from set temperature. Is this in firmware? It's been a while since I messed with firmware. Also, a few days ago I had a problem with the extruder temp shooting up from 210 to 290 while the disp…
-
Duh- you're right. Forgot I was trying from work and didn't set up wifi. So I got the file downloaded and installed (but I did have to change the path for the dpkg command that's listed above). Thanks for the site link but I had already checked tha…
-
No joy. Get: wget: unable to resolve host address 'download.repetier.com' Should I be trying this from the root or download directory?