hvashist
Hi All
Facing a strange problem.
I have setup my delta printer and using Arduino mega and ramps, Repetier 9.2.9 version of the firmware
The test files were printed perfectly fine.
When I am trying to print some STLs the printer stops suddenly it gives the following msg20:03:45.326 : ok 279420:03:48.419 : Unknown command:N56283 G-1029 T13 X0.00 Z0.00 F0.05 S1448498774 J0.00 R-0.00??????????????????????????????????????????????????start20:03:48.434 : Transformation matrix: 1.000000 0.000000 0.000000 0.000000 1.000000 0.000000 0.000000 0.000000 1.000000
Please help
About
- Username
- hvashist
- Joined
- Visits
- 13
- Last Active
- Roles
- Member
Comments
-
Thanks Problem somewhat solved as the spool holder printed without problem. Do you suggest that I should change to radds with extension board. I am planning to have a 5 color diamond hotend. Then I'll have 8 stepper motors. X Y Z and 5 extruders. …
-
Thanks Is there a way to change in EEPROM or other way My firmware has several changes after compilation. Changing to DELTASEGMENTS_PER_PRINTLINE to 22 seems to have around 1012 bites free for local variables.
-
Yes you are right. I meant receive buffer. When I compiled the sketch, following msg was displayed : Sketch uses 129140 bytes (50%) of program storage space. Maximum is 253952 bytes.Global variables use 7390 bytes (90%) of dynamic memory, leaving 80…
-
It shows a behavior of stopping any time during the print. I am bringing the STL file in repetier and slicing that with slicer. Then print. It prints a while and then stops. Is it that the ramps or arguing mega has less memory? I also tried to cha…
-
Can anybody help please !!
-
Can any body help/