DrAdam1986
About
- Username
- DrAdam1986
- Joined
- Visits
- 3
- Last Active
- Roles
- Member
Comments
-
I'll have a look, but I did do proper port forwarding to start with as stated in the guide. Thank you for the tip. I'll let you know later on!
-
Hi there! I have a similar issue. I have setup my repetier server on windows 11 and I can access it remotely using-my-house-IP:3344 via chrome browser on my phone, but only when I am at home. If I'm elsewhere it wont work. Just gives me timeout even…
-
Oh that's great. Many thanks for this!
-
Good morning! Thank you for your response. I don't use Linux,but windows 11. Is there an update coming for this too?
-
Oh thanks for clarifying. Any idea if I can use repetier informer for free if I have purchased light version? Until the callmebot is fixed for the light version that is.
-
Good morning! Thank you for the answer, unfortunately all the settings seem to be correct. As for the log, I am not sure where to find that. Lastly, I am still receiving only test messages. In the push messages settings it does say Pro Licence…
-
I just noticed. It's a function only supported in pro. I have light. Apologies.
-
Good afternoon! I have a somewhat similar issue. I just set up call me bot to send me push messages on my WhatsApp. Although it sends me successfully the rest message, it doesn't send me the actual notifications for starting/stopping/finishing…
-
So no problems so far! After I made the offset 0C, it's printing marvelously!
-
Thank you so much for your advice! That was it. If I may say this is a silly setting to have as default though. Now I set it to 0C and I will have another go. I'll keep you posted!
-
Hey there. I do have the same problem, although I have noticed a slight difference. In my case, although I set the bed temp in Prusa Slicer to be 65C, it ignores it and goes to 115C on multiple different prints. See my Prusa Slicer Code and note t…