SametAyhan
About
- Username
- SametAyhan
- Joined
- Visits
- 49
- Last Active
- Roles
- Member
Comments
-
Also, I detect another problem. The printed part has negative difference in dimensions compared to actual design dimensions. For example, I wanted to print 32mm diameter disk, but it printed approximately 30mm in dimension(max), oval shaped.
-
Hi, Have you solved the problem?
-
At long last, I solved the problem. The Autoretraction was enabled. I do not know how it is happened. I did research in the forum to have an idea to solve the problem. Finally, I disabled Autoretraction by sending the code "M209 S0(Disable Autoretra…
-
Hi, Dear Repetier, have you tried or tested v092.9 on any delta type printer?Please tell me more about the retraction problem. How do you retract (slicer based or G10/G11) and what happens and what did you expect? All you said is problem.
-
Additionaly, when I'm controlling the extruder stepper motor from LCD Panel(128*64), it can move forward and backward. Unfortunately, it does not move when I send the comments G10/G11 and I control from Repetier Host.
-
Retraction does not work. Also in the manual control of the extruder stepper motor does not respond the comments sent by Repetier Host (I try to retract on Repetier Host interface). When the printer is printing, stepper motor just stop, does not ret…
-
Hi again. I solved my first problem about going up when printing and elipsoid printing. It was about EEPROM Settings. I reseted everything in the Mega Board and uploaded again now it prints in the desired shapes. But the retraction is still not work…
-
Also, again there is a problem with retraction in v092.9. It was a problem for v092.8 and it was solved afret. I couldn't find firmware of v092.8. The retraction is not working in v092.9