FireflyNJ
About
- Username
- FireflyNJ
- Joined
- Visits
- 4
- Last Active
- Roles
- Member
Comments
-
I have a RepRapDiscount Full Graphic Smart Controller that I am running on a RAMPS 1.4 board. The display and the menu work fine until I connect an SD card. Then the entire thing slows down and in Repetier Host I get "SD card inserted" "SD init fail…
-
I have same issue, screen is just black on any view angle.
-
I had this issue, dryrun was on and would not stay off.But because of my inexperience (my first time building a 3d printer) did not know better not to check on 'have heatbed' and not have it connected.