Sci666
About
- Username
- Sci666
- Joined
- Visits
- 3
- Last Active
- Roles
- Member
Comments
-
It works in all cases! Maybe the Mini step test before Was not really usefull... Very Strange. Maybe I check this issue again with my spare control Board when it arrive.
-
Hello there. I found a solution that works. I Was able to connect the printer via usb to repetier host. I checke the eeprom settings and raise the step per mm for z. Axis from value 1600 which was the default to 2540. And Do some z-axis Tests and …
-
i swapped out the PSU ... no change in Z-Axis behaviour i checked in the printer display values for jerk and max feedrate for Z etc. and everything looks fine so far. so i tried to conenct the printer via usb ... unfortunately i got connection error…
-
so update: friction is not the problem i removed the threaded rods cleaned them up and put everything together. no change ... maybe the PSU gets weak ? because i noticed that the Heatbed needs really long time to reach the temperature of 60°C i…
-
mmhh good point i will check this first. maybe its a friction issue ... unfortunately i sawn some wood in the last days in the same room and the wood dust gets everywhere .... i try a dissasebly of the threaded rods and clean them up and oil them. …