Daneasch
About
- Username
- Daneasch
- Joined
- Visits
- 5
- Last Active
- Roles
- Member
Comments
-
I turned the Temp_Gain off, and on again, and Off again. And this indeed was the problem. When the gain is on the temp of the bed doesn't work
-
I did send a M500 behind the M502, but this has no effect. It could be the pid values are wrong, I never changed them from the website. I figured the were default and I'll fine tune later. Values were P196, I 33 and D was 92. Today I tried to remove…
-
I found out that if I send a M502 through the host, the printer displays the temp of the bed again. I added M502 to the startup_gcode in the firmware but this doesn't work. It seems like the eeprom values arent read, max jerk for example stays on 0,…
-
I retried, now with the filter of. below the values. The printer only works fine after I reset the Eprom, this has to be done after every reset of the board. without a reset I can set the values in the console, but they have no effect. Also in the h…
-
b.t.w. I didn't find an enable button for the bed, but did find a temp setting in the console, to witch the printer responds
-
I opend the console and set the buttons you suggested, below is the outcome. I did some more testing, and found that if I reset the Eprom with the button on the printer the bed temp reading comes back, even with the server active. If I reset with th…
-
How can I enable heater in server? I can only find the max temp settings for the bed, no enable button.
-
Hi Friend, The error was G30, and the sensor is an inductive one. Value of the sensor was good, measured it from the readings on the display. But I'm glad to say I fixed it. The problem was to stupid to think about. I'm Dutch, and so is my PC. we us…
-
Hi. I connected a Laptop to the printer with Repetier server, and repetier Host on my PC. I downloaded the Eprom settings but there is no setting for max extruder temp. can this be changed without reflashing? I would like to set the max temp to 310 …
-
Thanks, I'll give that a try.
-
Hello, Thanks for the Info.The board is a standard Rumba board, with Repetier firmware. Manufacturer went out off business in 2017. I did track the man down on LinkedIn but Unfortunately he doesn't see the need to mail with me, so that's a death end…