› ›

EinarSkog

Has going back to FW. 0,92 that working OK.

About

Username
EinarSkog
Joined
Visits
17
Last Active
Roles
Member

Comments

  • Hi My bad.  Worked with 10 cm long cables. Have just tried the RADDS + display on the desk. Not in a printer. Thr funny letters was with 50 cm cables, Worked also with 12 pin 10 cm and 10 pin 50 cm. Not with 12 pin 50 cm, 12 pin had continuity on al…
    in Strange letters on display. Comment by EinarSkog April 8
  • Hi Tried to double the delay on some lines. Not working. Do not know witch ones to delay.. I belived that chosing in firmware menu should be easy
    in Strange letters on display. Comment by EinarSkog April 7
  • Arduino:1.8.20 Hourly Build 2022/04/25 09:33 (Windows 10), Kort"Arduino Due (Programming Port)" C:\Users\EJS\Desktop\Repetier-Firmware\Repetier\ui.cpp: In function 'void slideIn(uint8_t, const char*)': C:\Users\EJS\Desktop\Repetier-Firmware\Repetier…
    in Strange letters on display. Comment by EinarSkog April 6
  • Hi. I try this, have never edited anything. I am more off a hardware man. I will report back.
    in Strange letters on display. Comment by EinarSkog April 6
  • Hi. It is the 20x4  display. Radds display in the menu. Cables ok. Can see letters but they give no meaning. There are 4 lines. After reset top line is for a brief moment "5gpgtggr 1.0.4"  4 line "urgntgr rggdy"  meaning "printer ready" ??
    in Strange letters on display. Comment by EinarSkog April 5
  • Gone back to 0.92 version
    in Main screen missing durring print Comment by EinarSkog April 2023
  • Hi Tried all the above, no good. Can anybody write down xactly what I shall type down into the ui.ccp file in Arduino.? Thank you 
    in Main screen missing durring print Comment by EinarSkog February 2023
  • SonjaDCUSA said: I don't see it. I have Home Positions for X,Y,Z and invert switches for each. But no "Park Position" I went through several times, just in case my old eyes missed it. Sorry, I use Repetier-Host
    in Geeetech A30T progress and bed display. Comment by EinarSkog January 2023
  • Find it in Config...Printer settings...Printer...Park position
    in Geeetech A30T progress and bed display. Comment by EinarSkog January 2023
  • I used Repetier-Firmware configuration tool for version 1.0.4 .And used Ardiuno to load into firmware.. Seem to me that I just used the standard items that came up.?  "RAMPS 1.3/1.4" and just picked the actual display
    in MKS Gen L 2,1 Comment by EinarSkog November 2022
  • I have Gen L version 2. Or maybe it is 2.1 Installed as ramps 1.4 in the Repetier firmware, and a 12864 lcd display. Before I had a english Melzi controller, also on Repetier firmware. 3D printer is a modified Reprap. Was made off 8mm treaded rods.
    in MKS Gen L 2,1 Comment by EinarSkog November 2022