Sakgoo
About
- Username
- Sakgoo
- Joined
- Visits
- 5
- Last Active
- Roles
- Member
Comments
-
Ok. I will reconfigure the software for version 1.0.5. I have a few questions here too. I am using arduino mega as card. Can I choose EEPROM_MODE = 2 on this board. Does it work. For bed leveling, I don't want it to do it again with every print. I w…
-
Software version 1.0.4 installed. I copied the errors in the compiler into a text document and I'm sending you the link. Hata txt belge link: https://yadi.sk/d/b4_Xxy99FN0mkQ
-
Hello, I've solved my other problem, but now I'm getting such a problem while compiling.
-
But it's arranged that way in software
-
Should I change "#define Z_PROBE_X_OFFSET 0" and "#define Z_PROBE_Y_OFFSET 0" then?
-
Thank you so much. Good work.
-
Repetier said: uilang.h around lines 3869 #define UI_TEXT_BED_TEMP_TR "Tabla Sic: :%eb/%Eb" cDEG "C"#define UI_TEXT_EXTR0_TEMP_TR "Sic. 1 : :%e0/%E0" cDEG "C"#define UI_TEXT_EXTR1_TEMP_TR "Sic. 2 : :%e1/%E1" cDEG "C"#define UI_TEXT_EXTR2_TEM…
-
Repetier said: Image does not work. My initial guess is that the translation is broken. Please check in uilang.h for the english text you see - it might exists several times. The critical parts are the %xx parts that get replaced by the …
-
Repetier said: Ok, so no bug. Only issue is that when printing we remove the control entry in menu as that contains a lot of "bad" commands that destroy print when executed during print. So that won't change, but you can modify it if you like…
-
I am sending two videos for you. We can solve the problem faster and easier. The 1st video is in Turkish and if you notice, I cannot interfere with my case leds on the screen after I start printing. If I pause printing then I can enter the main …
-
Hello again, My case leds are connected to the correct pin and are working. When the printer is idle, I can choose "Lights=On" or "Lights=Off" in the menu. The problem is that I cannot enter the menu while my 3D printer is printing. I can only see …