ITFAB
About
- Username
- ITFAB
- Joined
- Visits
- 7
- Last Active
- Roles
- Member
Comments
-
You are correct, upgrading to 1.4.10 did the trick. Excuse my mistake and thanks a lot for the assistance.
-
In global settings-> MQTT it just says "MQTT - Disconnected". No error messages. My server.log when I reboot the server is: 2023-06-13 12:22:17: MQTT connection lost 2023-06-13 12:22:17: Websocket: Client closed connection unexpectedly2023-06-13…
-
Done! I've installed the dev version (1.4.9) and it works just fine. So, the problem is solved, thank you very much.
-
Yeah I see the usual dialog boxes in Repetier-Server (UI and TouchScreen). Everything is the same as usual, only difference is the printer stops responding after the filament unload process (only with versions after 1.3.0).
-
Thanks for the quick response. It doesn't seem that the max. extrusion length is the issue. This is our firmware (Marlin): //#define PREVENT_LENGTHY_EXTRUDE#define EXTRUDE_MAXLENGTH 30000 And this is our console output at the time of the problem: …