Couture619

About

Username: Couture619
Joined: May 2015
Visits: 29
Last Active: February 2017
Roles: Member

Comments

Thank you so much! I am having one more related question. What is you maximum achievable speed without losing step? I know there is a lot of variable but I can’t get pass 100mm/s is it normal. Here’s my setup Stepper : 640 step/mm motors : 92 oz-i…

in Radds + raps128 Delta optimal advance settings Comment by Couture619 January 2016
Here's my config file. I am still tweaking thing but it work quite well. https://www.dropbox.com/sh/lq7lcifbu1ytu5t/AAAUoGjSx0SXED9e2aQa7PPoa?dl=0 Radds 1.5***raps128***Delta ***Proximity probe***heatbed***one extruder***

in New to Repetier setting up RADDS+DUE+RAPS128 Comment by Couture619 January 2016
Turn out it was my due (which I bought from reprap.me) that was in fault. A big thanks to all Repetier Team great work!

in Thermistors Problems - Radds 1.5 - Delta printer Comment by Couture619 January 2016
Thank for your time. What I have did so far: 1 – Check my thermistor they are around 128kohm – they work 2 – Connect them to other pins – All the same, didn't work3 - Play with the pins numbers in the config.h file - try a lot of them didn't work 4 …

in Thermistors Problems - Radds 1.5 - Delta printer Comment by Couture619 January 2016
Here is my config.h file https://www.dropbox.com/s/hlspl8z0gr1hqv2/Configuration.h?dl=0

in Thermistors Problems - Radds 1.5 - Delta printer Comment by Couture619 January 2016
Thank you!

in Delta extruder Offset Comment by Couture619 June 2015
I am using the Repetier-Firmware configuration tool for version 0.92.3

in Delta extruder Offset Comment by Couture619 May 2015