genio123
About
- Username
- genio123
- Joined
- Visits
- 3
- Last Active
- Roles
- Member
Comments
-
null Edited the P points as you said and i absolutely love it !!! Perfect bed leveling !!!!
-
Got it ! So i have to calculate P1,P2,P3 keeping in mind that those points have to be reached by the probe.. so keeping 1~2cm away from the borders is a good practice? Right ?
-
I've fixed the probe to the extruder mount and started playing with the auto leveling ... I'll keep you updated... Sending u 10 euros for the help! Cheers!
-
Ok... i'm finally crying of joy because it works... the mistake was in a youtube video i was following... the correct pulse is 647 instead of 700... i didnt know that... i can confirm that pin 27 is A4 in melzi P802M motherboard! Now i have to under…
-
I'm using the online config tool and in servo i selected servo0 with DIGITAL PIN 27, it's correct??
-
I've checked the configuration for Mobo 63 in your firmware ... Pin 27 should be free and it should be that ... 28,29 etc are busy by the LCD... And from your schematics it should be A4, I've also ordered an original BLTouch just to be sure that is…
-
Oh! Do you know if could be a power problem ? Do i have to attach a separate 5v source for that ? Also, if yes , i have to bridge the GND of the external PSU to the GND of the board ?
-
The sketch i tried is just for my Arduino uno, not for the melzi... So I'm sure the sensor work. I still have to figure out how to attach the servo to a pin of the melzi ... I'll attach my config asap , also ... Melzi is a 1284... Sanguino compatibl…
-
I've looked around all the repetier firmware, and after a while i've selected pin 27 , as it seems free.... After assigning pin 27 to SERVO0, i've tried to launch M340 P0 S700 or M340 P0 S1400... nothing happens... what it could be? EDIT: I've also…