› ›

ekaggrat

About

Username
ekaggrat
Joined
Visits
18
Last Active
Roles
Member

Comments

  • thanks for the prompt reply! . it works like a charm . i have one issue though. The command seams to timeout in some time. what is the timeout period? I need a longer duration to pause to glue the fabric pieces in place before continuing the print! …
    in pause at particular layer in gcode from sd card Comment by ekaggrat October 2021
  • it is using the same pins as serial 1. the esp3d doesnot use the second serial . So in that case can i still connect the usb and see whats wrong?
    in esp3d reset on connecting to ramps Comment by ekaggrat June 2018
  • the thing is even i suspected that,, i ran the entire print via the host in debug mode and i saw the output.. there was always number of steps showing 104-95 % ... didnt miss any . i ran the print also via the sd card with the jam sensor disabled . …
    in fts sensor error Comment by ekaggrat January 2018
  • ok i think i now understand and it is normal behavior i guess..  on another note is it possible to make the printer from dual to single extruder on a flick of a toggle switch? Basically if one pin goes high the printer thinks it is a single extruder…
    in dual extrusion offset error Comment by ekaggrat July 2017
  • okay i tried out g33 but it didnt seem to help me get the bed completely level, i will try with more points.. but now there is another strange thing going on. m502 is supposed to load factory defaults and m500 saves them.. But in my case no matter h…
    in proper process of bed leveling Comment by ekaggrat March 2017
  • i got the dev version and got g32 s2 to work like a charm and g30 and g29 also work.. i leveled my bed using grid leveling and did a print asnd it printed fine.. My other issue is that i am using bed leveling because my bed has a slight bend in the …
    in proper process of bed leveling Comment by ekaggrat March 2017
  • okay got it,, thanks for the response... I think a possible way would be to save the state with octoprint and then issue the gcode from where the printer left after homing... and setting the temperatures. thanks 
    in save state on power failure Comment by ekaggrat January 2017
  • but there is a similar function to hault on filament jam.. so in a similar way if on click on a menu item in the lcd, the printer is paused and the last xyze is stored in the eeprom and on resume it continues from there.. isnt that possible?
    in save state on power failure Comment by ekaggrat January 2017
  • my lines are worse.. kind of stuck here..  i have the sd6128 running on the ramps.. i even have a4988 and drv8825.. the issue stays with all
    in Odd vertical lines showing up Comment by ekaggrat May 2016
  • did you find a solution . i am also having the same problem on my corexy with ramps and sd6128
    in Odd vertical lines showing up Comment by ekaggrat May 2016