Kaji

Comments

• Allright. I'll see what I can do and report it later when I have time. I'm little busy now.

  in Can't compile firmware (Sanguinololu v1.3) Comment by Kaji May 2015
• Looks like there is still some problem with even latest CuraEngine.. http://kaji.fi/stripe_in_preview_2.png http://kaji.fi/stripe_in_print_2.jpg

  in Problem with Spiralize Contour Comment by Kaji May 2015
• Thank you for slic3r tip. It seems that new CuraEngine makes infill before perimeters and I don't like that much, but I noticed that there will be option in repetier fork of CuraEngine for that, but I don't have enough knowledge to compile CuraEngin…

  in Problem with Spiralize Contour Comment by Kaji April 2015
• I updated CuraEngine to latest 15.02.1 and problem was solved! I could not use Slic3r as exporting gcode would take forever to finish.

  in Problem with Spiralize Contour Comment by Kaji April 2015
• Ah.. it was not finnished yet and what was on screen was from previous slicing. There is some problems though.. http://kaji.fi/Slic3r_vase_2.png

  in Problem with Spiralize Contour Comment by Kaji April 2015
• Humm... I sliced this with Slic3r and I got same stripe... http://kaji.fi/Slic3r_vase.png

  in Problem with Spiralize Contour Comment by Kaji April 2015
• Yes thought so too. Hopefully it will be fixed at some point. Maybe I contact directly CuraEngine, but I think this is known problem. This doesn't happen in all vase prints..

  in Problem with Spiralize Contour Comment by Kaji April 2015