jbabio
About
- Username
- jbabio
- Joined
- Visits
- 27
- Last Active
- Roles
- Member
Comments
-
:-O OMG! thanks I've waited for your answer... At the end, direct 5v and one on/off switch will be the best option. Thank you again!
-
I've the Geetech fan extender board wich is capable of delivering 0.5A per channel. since I'm only using one output for the extruder fans, should it work if I connect the BT module to the other output?, Ive measured 4.8v coming out If I set fan spee…
-
Anyway, the printer is printing very nice with extrusion multiplier set to 6 so, if it works... Don't touch it XD If I have time in the future, I will freshly install the host in other computer to see if there works OK. Thank you very much for your…
-
I've made no modifications to Slic3r after update and prior to the firmware update extrusion worked fine. I've triple checked that volumetric extrusion is disabled and even activated "relative E" and volumetric extrusion, saved then disabled and sav…
-
Now I've a different problem, this time is extruder related. With the previous firmware the extrusion flow was correct (Actually I had to low flowrate to 0.93) but with 0.02.8 the flow rate is very small even at 150% extrusion. No changes were made…
-
Hi, moving Y to 100 prior to starting the probing process seems to work! If I understand well, firmware will move the head to offseted position prior to start the Zprobing moves. Since I'm using Y-max endstop it can't be done. Correct? Anyway, tha…
-
Note: I also tested setting up #define Z_PROBE_Y_OFFSET 25 (positive) but the printer behaves exactly the same.
-
Thanks for the suggestion That's how I'm doing it right now.