headsmess
About
- Username
- headsmess
- Joined
- Visits
- 7
- Last Active
- Roles
- Member
Comments
-
thanks for the fast reply yep...i tried pressing that reset button many times, and then... it worked. ive now reflashed about 7 times since making this post... and there shall be more to come as i tune everything up...but! its finally starting t…
-
update... i held the reset button, until compiling complete then let go for the upload. and marlin settings flashed without the sync error. LED is now flashing at 1hz, and to make sure it isnt that lil snippet i put on the eeprom earlier...erased …
-
muchness prinitings still havent crashed despite flicking around with tabs and new files, slices etc... even tried loading up some gcode from the sd card via g-code editor and some cutnpaste. and viola, it previewed AND its printing right now!
-
update...i think its fine now. just updated to the new version...154? installed skeinforge with it, cus it appears theres a glitch there...select it to install slicer but i cant unselect that skeinforge and the 139mb download that comes with it... …
-
theyre baaaaack! ha ha, it was brief. wasnt it? sorry. i ramble... over elaborate... sometimes under elaborate... thanks for the reply ok, the python stuff was because of a wiki goosechase... thats gone now. as is pronterface i think. still on repe…