Strange Radds behaviour
Hello friends, i have a delta printer, i have changed my hardware configuration from ramps to radds 1.5.
I don't use on board drivers but three leadshine dm442. These drivers work fine with arduino mega and ramps but with arduino due and radds i have same problems.
In particular everything work fine in manual move and extrusion control, but any printing session, regularly start, slow down and stop after few movements (like in the movie), after few seconda start to move properly then it slow down and stop again.
Some idea?
Thanks!
I don't use on board drivers but three leadshine dm442. These drivers work fine with arduino mega and ramps but with arduino due and radds i have same problems.
In particular everything work fine in manual move and extrusion control, but any printing session, regularly start, slow down and stop after few movements (like in the movie), after few seconda start to move properly then it slow down and stop again.
Some idea?
Thanks!
Comments