Renkforce RF2000v2 (Board 3.0 with factory-i2c-Port)
Hi!
Is there any way to access (send commands) via i2c out of the gcode? I tried that on an Anycubic i3 with Marlin and it works fine. But i am new to Repetier and as the Board (as far as i know) wouldn´t deal with Marlin i am stuck.
Can anyone give me a hint, what to do (if there´s an option to do something...)?
Kind regards,
Andy
Is there any way to access (send commands) via i2c out of the gcode? I tried that on an Anycubic i3 with Marlin and it works fine. But i am new to Repetier and as the Board (as far as i know) wouldn´t deal with Marlin i am stuck.
Can anyone give me a hint, what to do (if there´s an option to do something...)?
Kind regards,
Andy
Comments
Kind regards,
Andy
https://asset.conrad.com/media10/add/160267/c1/-/en/001395717CD01/schema-electrique-1395717-renkforce-rf2000-imprimante-3d-appareil-pret-a-lemploi-banc-dimpression-chauffant.pdf
The file commands.cpp contain all gcode-interpretations. Need to find a way to establish the communication.