›

Filament Use (amount used)

one_eyeone_eye
in Repetier-Firmware
Printer: DaVinci 1.0A
Mac OSX ElCapitan
Arduino
Repetier Firmware 0.92

When finished printing, the accumulated total of filament printed is displayed.  I want to reset that amount (so I can track usage on individual reels of filament).  How to do this?  I searched the site but found nothing...  I don't see an M-code or info about what coding to change...
Thanks

Comments

  • RepetierRepetier
    It is stored in eeprom, so just open eeprom editor to change it to 0. Then you also see the command send in log to do so. M206 ....
  • one_eyeone_eye
    Thank you.

    First thing I did was M206  - that displayed a Transformation Matrix (several values but nothing I needed).

    Then, in Config.h I set Eeprom to 0 (it was 1) and uploaded.  Received compile error saying sdeeprom error from HAL.h and requiring setting Eeprom to 1.

    So, I'm not sure what M206 was supposed to do (regarding being able to reset filament print use to zero) as well as the eeprom error...
  • one_eyeone_eye
    Follow up - M206 is correct; just needed to use correct arguments... Thanks
Sign In or Register to comment.