Disable acceleration for laser mode
Hello.
This is my firsts experiences with laser engraving.
I have noticed that the "printer" still accelerating the motors even in laser mode, the burn it stronger in the line start and as it accelerates the burn is lower again then stronger at its end, and I believe it is because of the acceleration.
So:
1. There a way to disable the acceleration?
2. There a way to disable the acceleration just in the laser mode?
3. There a way to disable the acceleration just in laser on moves but not the travel moves?
Thank you very much.
This is my firsts experiences with laser engraving.
I have noticed that the "printer" still accelerating the motors even in laser mode, the burn it stronger in the line start and as it accelerates the burn is lower again then stronger at its end, and I believe it is because of the acceleration.
So:
1. There a way to disable the acceleration?
2. There a way to disable the acceleration just in the laser mode?
3. There a way to disable the acceleration just in laser on moves but not the travel moves?
Thank you very much.
Comments
(M202 - Set max acceleration in units/s^2 for travel moves (M202 X1000 Y1000))
There is a way to set the jerk by g-code? It is a permanent setting?
Might still end in eeprom if you later store eeprom like when all heaters get disabled, so better always set back to start values after usage.