Linux mint installation problem, Repetier don't see Tevo Flash and reduce speed of computer
here Enrico from Italy
i have a Linux Mint Kernel: 4.15.0-45-generic x86_64 (64 bit) Desktop: Cinnamon 3.6.7 Distro: Linux Mint 18.3 Sylvia
i have a Tevo Flash with Marlin oriinal (pre-installed. V 1.0)
The printer is new, sent to me on november 2018.
I had try download and install both repetier for linux (image and compile)
both have same problems: when i open software it let me change settings but when i go to choose firmware type he only accept AUTODETECT, i can0't select Marlin or others
i can change parameters, but when i press connect nothing happend, from tty list i know i have it connected on ttyUSB0
i have try other solution, nothing happend.
i have try repetier onwindows 10 and it work, it comunicate and i can move manually the tevo
evenif i have an error there too: nothing happend when i try command manually the extrusor....
i wait help....