Incessant "Wait" Commands
I have an Arduino/RAMPS loaded with Repetier Firmware that I am trying to get set up with Repetier Host. However, when I connect the printer to Repetier Host in the log it just says "wait" over and over. I can send commands to the printer; however, the motors will not move and I recieve the message "Warning: Seems like we missed a ok, got a wait - continue sending." I have checked the baud rate in the firmware and host and they match. I also have the correct COM port selected. I was able to upload sketches to the Arduino so I assume that I have the right driver installed. Any idea what is happening?