Changing minimum extruder temperature to 27°C / 80.6°F
Hello all!
I am slowly upgrading my Wanhao di3 clone and I installed a RAMPS and chose to use Repetier on it.
Now in the future I want to print a clay-based fillament (Beane Industires - Kickstarter) and I will be suppose to print it with a hotend temperature of 27°C (80.6°F). But the minimum temperature isn't nearly that low.
What would a workaround be in the configuration file to be able to get this low temperatures?
Kind regards,
I am slowly upgrading my Wanhao di3 clone and I installed a RAMPS and chose to use Repetier on it.
Now in the future I want to print a clay-based fillament (Beane Industires - Kickstarter) and I will be suppose to print it with a hotend temperature of 27°C (80.6°F). But the minimum temperature isn't nearly that low.
What would a workaround be in the configuration file to be able to get this low temperatures?
Kind regards,
Comments
would even allow cold extrusion, so no temperature limit. Hope heater works with that temperature at all. Remember some <30 or room temperature comparisons to decide if it is on at all. This is protection that normally has no problems with filament but heating to such low temperatures is not easy I guess. Easy to trigger decoupled temperature in summer for example if room temperature is already higher.