Rostock Max V2/ramb0 with the Prometheus System.

dbfrompw · December 2017

I've been trying to get V0.92.2 working with dual extruders and single hotend for about a month. Every time i try and switch to E1 in S3D or any other slicer software, it completely locks up and has to be power cycled. I did have some success with V0.91S. So I did try the configuration tool on the Repetier web site. I copied all the settings that worked on V0.91S AND even hooked up a Reprap Full Discount Graphics LCD and WOW it came up. BUT, it didn't move like it should. When I tried to home it, it would go home then back down to about 200mm from the bed. Also, if I tried to move the axis, it would move 20mm or so when the screen would say 1.0mm When I tried to heat up the bed and hotend i got nothing. I double check all the steps per mm and the pins.h file all match what I had on V0.91S.

I'd like to set up inductive mesh probing also.

Any help would be great!!

Repetier · December 2017

Switch to 1.0 especially for probing. Make sure to have at least 900 byte free ram. To optimize handling we precompute path and that takes ram. If oyu have less reduce subsegments per line. If you have not enough free ram strange things can happen.

dbfrompw · December 2017

Link to 1.0 please! Is there an on line configuration tool?

RAyWB · December 2017

https://www.repetier.com/firmware/dev/index.php

Rostock Max V2/ramb0 with the Prometheus System.

Comments