Delta Endstop Configuration
If you have a Delta machine (Kossel, Rostock) then you probably have max endstops set up at the top of your machine.
What really confused me is how Repetier understands these endstops. The truth is, it's pretty simple. It's not treated like a cartesian printer, where Z is vertical. Z is usually your back post.
So, my machine has endstops at the top, and a effector probe (Z Probe). Typical of most Deltas. Here's how it's set up:
Endstops:
X Min: Not Installed
Y Min: Not Installed
Z Min: Not Installed
X Max: Yes (Mine are mechanical, normally closed)
Y Max: Yes (Mine are mechanical, normally closed)
Z Max: Yes (Mine are mechanical, normally closed)
Z Probing:
Z-Probe Enabled: Yes
Z-Probe Pin: Z Min
Comments
http://www.buonevacanze.org/EndStopsConfig.html