Autoleveling error, Nozzle scratches the bed
Hello!
I am a newbie, so I apologize if I say some stupid or my English is bad.
I Follow the indications in the documentation"documentation/repetier-firmware/z-probing/"
And calculate a distance to the bed of 1.64 mm, but when it starts to print I scratch the whole bed. I had to touch bed coating by hand, and just in 2.10 mm it worked.
I probe to move the z axis 10cm and was well calibrated.
I am a newbie, so I apologize if I say some stupid or my English is bad.
I Follow the indications in the documentation"documentation/repetier-firmware/z-probing/"
And calculate a distance to the bed of 1.64 mm, but when it starts to print I scratch the whole bed. I had to touch bed coating by hand, and just in 2.10 mm it worked.
I probe to move the z axis 10cm and was well calibrated.
any ideas?
Thx!
Comments
this?