Error 0x00 when uploading
Hi everyone,
I am having a few issues when trying to upload Repetier firmware onto my Generation 6 deluxe electronics. Using Arduino 1.0.1, I get the following error just before it uploads...
avrdude: stk500_getsync(): not in sync: resp=0x00
Or sometimes this error;
avrdude: stk500_getsync(): not in sync: resp=0x89
From what I have searched there is some kind of communication error but everything I have tried so far hasnt helped?
Does anyone have any idea what it could be?
Thanks
Comments
In regards to the axis compensation, I have enabled both the z probe and the compensation in the features menu. Is there anything else I need to do? At the minute I have a print that comes out at 88 degrees and no matter what I change the value to, it doesn't change