HELP PLEASE - strange terminator problem with 235 degrees = 90
i had a problem with the heated bed not working due to the temp was not registering.
so i bought new thermistors for the bed
i bought the RS-com[ponats model from the drop down list in the firmware
RS Pro 100kΩ DO-35 Measurement NTC Thermistor, 7s, 2 (Dia.) x 4.2mm
so i re-did the firmware settings and restarted the printer.
the starting temp is showing as 88 degrees and would not rise when the bed was turned on
so i did a little experiment by heating the thermistor along with a multimeter thermistor with a flame the thermistor in the firmware did not rise untill the mutimeter got to 235 degrees then it went up to 90 degrees.
so i do have the right pin but something is wrong.
just a little footnote the hot ends do not report the correct temp on start up but are ok after heating beyond 40 degrees.
might help
Comments