Toggle navigation
Categories
Discussions
About Us
Privacy Policy
Sign In
Home
›
Repetier-Firmware
angle correction Y tower delta printer
Jerome
April 2017
in
Repetier-Firmware
My X-tower is exactly 120 degrees from the Z-tower. However the Y-tower is 119 degrees from the Z-tower.
How do I correct this difference?
Thanks
Comments
Repetier
April 2017
Set Y angle to 229° so X-Y is 119° and Y-Z 121°.
Jerome
April 2017
Hi,
can I change this in eeprom settings?
If yes how and where.
What is the difference in eeprom between 'corr diagonal' and 'dealta radius' ?
Thanks again
Repetier
April 2017
Yes you can chane them all in eeprom.
Corr diagonal gets added to diagonal length. Delta radius is the horzontal radius when centered.
Sign In
or
Register
to comment.

## Comments

What is the difference in eeprom between 'corr diagonal' and 'dealta radius' ?