›

Printer not printing!

harristhepoodleharristhepoodle
in Repetier-Firmware
Hi, I've recently purchased a new board for my printer, and everything works, including manual control, however when I come to print it, it moves to the endstops but doesn't print, but it says so on the repetier host.

I am getting this error

11:24:50.849 : Error:Printer set into dry run mode until restart!

As well as:

11:24:59.203 : Other:: working marked decoupled

bed and everything heats up and works correctly

Any suggestions?

Comments

  • RepetierRepetier
    Look earlier in the log. Your extruder seems to trigger the decoupled test. So it is either configured wrong or it heats slower then assumed and you need to increase decouple time for that. Log should show more info at the time decoupling is detected.
  • harristhepoodleharristhepoodle
    Repetier said:
    Look earlier in the log. Your extruder seems to trigger the decoupled test. So it is either configured wrong or it heats slower then assumed and you need to increase decouple time for that. Log should show more info at the time decoupling is detected.
    Where can I chage these settings?
  • RepetierRepetier
    In our online config tool or configuration.h directly.
  • harristhepoodleharristhepoodle
    Repetier said:
    In our online config tool or configuration.h directly.
    what do i need to change?
  • RepetierRepetier
    Decouple test period / EXT0_DECOUPLE_TEST_PERIOD would be my guess.
Sign In or Register to comment.