Which NTC?
Hi,
I got a question about an NTC because I think the temperature of my extruder an bed are lower than expected.
See these NTCs please:
www.dropbox.com/s/58heho2y3lo3g0w/a.jpg?dl=0
www.dropbox.com/s/yp5py4ldd2a8eos/b.jpg?dl=0
They are out of a Kit for an Anycubic Kossel Plus.
The firmware which is delivered with the printer (Marlin) is preconfigured, and the type configured is 104GT-2
But I think this is wrong. The NTC look way more like a NTC3950. These are sold by Anycubic on Aliexpress a lot.
At 110°C they differ in 10°C. At higher temperatures even more.
Can somebody confirm a type from the pictures for sure?
Thanks.
I got a question about an NTC because I think the temperature of my extruder an bed are lower than expected.
See these NTCs please:
www.dropbox.com/s/58heho2y3lo3g0w/a.jpg?dl=0
www.dropbox.com/s/yp5py4ldd2a8eos/b.jpg?dl=0
They are out of a Kit for an Anycubic Kossel Plus.
The firmware which is delivered with the printer (Marlin) is preconfigured, and the type configured is 104GT-2
But I think this is wrong. The NTC look way more like a NTC3950. These are sold by Anycubic on Aliexpress a lot.
At 110°C they differ in 10°C. At higher temperatures even more.
Can somebody confirm a type from the pictures for sure?
Thanks.
Comments
For me it would be great to see real absolute temperatures. If I switch the printer it would be good to know the temperatures for the laminat as absolute values.
Therefor I need to measure with a calibrated tool to get the B-Value right.
Thanks for your answer.