› ›

Servo pins

3dMistery3dMistery
in Motor Control

Hi!

Can someone please tell me how to get voltage on servo pins on RAMPS 1.4?

Would ticking "enble servo support" in firmware configurator be enough or I need to do something else?

Comments

  • RepetierSupportRepetierSupport
    You need to power the servo pins. See RAMPS pin definition in www.reprap.org ramps description. It is near the 4 servo pins. This should be a poer source having enough power to run the servos! So don't take it from the arduino directly. Pin numbers are also in the diagramm.
  • 3dMistery3dMistery
    Thank you!
Sign In or Register to comment.