› ›

Dual extruder but only one move

raymondraymond
edited November 2016 in Extruder & Bed
Hi,hope somebody can help me with this.
I config the repetier firmware 0.92.9 version with the online config tools,dual extruder, when I test my printer,all steppers move pretty well  except the one for  extruder 1, when I move it on LCD controller, with temperature reach minimum,
image
As showed in this photo,the E on the top is alway 0.00mm,yet the E below moves though, and motor doesn't move a bit.

The other motor for Extruder 0 works perfectly.I don't know what happen.Could somebody tell me what to do?

Comments

  • RepetierRepetier
    You might have set steps per mm in eeprom to nan or 0. That would cause such problems. Happens especially if you had 1 extruder config in the past. In that case also check the other eeprom values for extruder 1.
  • raymondraymond
    Repetier said:
    You might have set steps per mm in eeprom to nan or 0. That would cause such problems. Happens especially if you had 1 extruder config in the past. In that case also check the other eeprom values for extruder 1.
    Thanks!I overwrite the EEPROM and it works!
Sign In or Register to comment.