G92 not working in V1.0.5
I haven't printed since January when I was using 0.95D...
Just updated to 1.0.5 and tried to set Z height zero using G92 Z0...
Before entering the command, the display read X: 100.00 Y: 80.00 Z: 0.42
After sending G92 Z0 the display now reads: X: 100.00 Y: 0.00 Z: 0.84
As you can see there are two things wrong with that:
1) It doubled the Z height instead of zeroing it
2) It zeroed Y
Comments