Printer crashes on Z homing
Lost again...
I have firmware 92.3, here's my Configuration.h.
Whenever I home Z (with Repetier Host, Octoprint or the Panel on the printer), the axis goes up and stops in the moment the endstop is hit. I use the "go back and hit again"-mode, but it just hits once. After that, the printer is dead, no reaction on dialing the display knob or communication from Repetier host. I also did a M502, M500 and reinstalled the firmware to the printer. Nothing helped.
Cheers, Ralf.
I have firmware 92.3, here's my Configuration.h.
Whenever I home Z (with Repetier Host, Octoprint or the Panel on the printer), the axis goes up and stops in the moment the endstop is hit. I use the "go back and hit again"-mode, but it just hits once. After that, the printer is dead, no reaction on dialing the display knob or communication from Repetier host. I also did a M502, M500 and reinstalled the firmware to the printer. Nothing helped.
Cheers, Ralf.
Comments