wich settings for E3D PT1000 temp Sensor
HI there,
i would like to switch to a PT1000 temsp sensor at the extruder. E3D means there is no amplifier bord needed (like at the PT100) - is usable with a 4,7k pullup resistance.
I need to know how to set this sensor in the firmware. What type of sensor? and do i need a special sensor table?
and than the stupid question where is to install the resistance (which line/polarity)
My printer (GRR X350) have a Megatronics board
i would like to switch to a PT1000 temsp sensor at the extruder. E3D means there is no amplifier bord needed (like at the PT100) - is usable with a 4,7k pullup resistance.
I need to know how to set this sensor in the firmware. What type of sensor? and do i need a special sensor table?
and than the stupid question where is to install the resistance (which line/polarity)
My printer (GRR X350) have a Megatronics board