Mega 2560 + ramps 1.4 + tb6600 + grbl = false. Pls help!

leonhuynh2006 · October 2019

Hi all pro,

I am new in CNC. I have connected mega + ramps + tb6600 as enclosed photo.

I used grbl 1.1 mega 2560 version, selected the right port (COM 3), the right board (mega 2550) in Arduino IDE. Uploading firmware was ok.

But when I tried to test it by using Universal GCode Sender manually, but the motor didn't spin

Did I miss out something. Pls helpppppp

Thanks

RAyWB · October 2019

wrong forum here , this is for repetier firmware.

Maybe you can find help here :

https://forum.shapeoko.com/

shapeoko is known for using GRBL Firmware

Mega 2560 + ramps 1.4 + tb6600 + grbl = false. Pls help!

Comments