Z-probe hight- software indiferent to changes
Hi everyone!
I have a curious issue relevant to Z-probe Hight... Whatever value i introduce in the eeprom, after start printing g32 command ect.. The hight of the nozzle is always the same.
it dosn't happen when homing the z axis, in this case the nozzle reach the correct bd distance.
any one had the same strange behaviour.
Thanks in andvane for any support, i'm going really crazy about that....
I have a curious issue relevant to Z-probe Hight... Whatever value i introduce in the eeprom, after start printing g32 command ect.. The hight of the nozzle is always the same.
it dosn't happen when homing the z axis, in this case the nozzle reach the correct bd distance.
any one had the same strange behaviour.
Thanks in andvane for any support, i'm going really crazy about that....