Z Sensors

2»

Comments

  • >Is there an 'M' command for setting Z_PROBE_Z_OFFSET et Z_PROBE_HEIGHT ?

    Yes, they are store din eeprom so M206 can change them. Use eeprom editor and enable log to show commands send. Change them and save. Then you see in log which position and type to use in M206.
  • edited April 2019
    I just looked at the syntax for this command that I did not understand ...
    Cool, here's another point resolved.
    I will just forget about the 'temporary' and store in the Eeprom.
    Thanks
Sign In or Register to comment.