Putting PID info into arduino sketch
I've been trying to change the PID settings in configuration h. under Heated Bed but the results don't change.
Where do I put them to get recognized when I look them up in EPROM Settings?
I've been pulling power and reloading RepHost.
// ############# Heated bed configuration ########################
...
Where do I put them to get recognized when I look them up in EPROM Settings?
I've been pulling power and reloading RepHost.
// ############# Heated bed configuration ########################
...
#define HEATED_BED_PID_PGAIN 196
#define HEATED_BED_PID_IGAIN 33
#define HEATED_BED_PID_DGAIN 290
Comments
M502
M500
to copy new configuration.h changes to eeprom. Alternative change them in an eeprom editor directly.