› ›

Repetier Host 2.1.3 manual control not retaining g92 information

MikatDudeMikatDude
in Bug Reports
Repetier Host 2.1.3 manual control not retaining g92 z(nn) information, which is preventing the ability to calibrate the z-axis when fitting an inductance sensor, I had to revert to Repetier Host 1.6.2 to be able to calibrate the auto bed leveling of the inductance sensor.

Comments

  • RepetierRepetier
    Why does it prevent it. I know host shows coordinates including G92 offset so it always shows absolute position but you can still send any command unchanged. In CNC mode it would even not include the offset.
Sign In or Register to comment.